bonjour et merci pour ta réponse, merci aussi pour le fait que les potars on etait monte a l envers je ne l avais pas remarqué.
On essaye de faire fonctionne un module edis 8 complet
Pour le moment on arrive a rien vis a vis de l allumage et de l aquisition du signal de la rue denté 36/1.
Il paraitrai que un edis non connecté a un ms doit quand meme donné de l allumage?
je pense que pour une megasquirt le montage qui etait correcte etait celui la
On the V3.0 main board:
use the 'Hall sensor circuit' (step #50.a in the assembly guide) - jumper D1 and D2,
jumper OPTOIN to TACHSELECT on the bottom side of the PCB, near the DB37 connector, opposite the heat sink,
jumper TSEL to OPTOOUT on the bottom side of the PCB, near the center.
jumper JS10 to IGN (this uses the processor port for the SAW signal directly),
jumper XG1 to XG2 on the bottom side of the PCB, near the 40 pin socket